A few months after my purchase of the Philips N4520 tapedeck, it developed a nasty fault: during playback there would be cracking sounds coming through the music, or even when not playing at all. Also when touching the knobs, there would be pops and clicks.

An intensive internet search revealed that there were more decks affected with the same symptom. Fortunately, a remedy was also given: replace the transistors on the main circuit board with new ones. Gulp. All 19 of them.

I have some experience with soldering, but this was a completely new level for me. I happen to be in possession of a very good soldering station with temperature control, and I have used litz wire once or twice, to remove solder of the component you want to remove.

IMG_20131101_171351IMG_20131101_171428So, I ordered the necessary components on-line:

 7x BF245A : TS2 TS5/TS105 TS4/TS104 TS3/TS103
 1x BC547 : TS11
 4x BC548 : TS8 / TS108 TS9 / TS109
 2x BC549 : TS1/101
 1x BC557 : TS10
 2x BC546A : TS6/106
 2x BC556A : TS7/107
IMG_20131101_135434

My new friends

Total number of transistors: 19 pcs.
Total cost: around € 10,- excl. transport.

Then, the scary part started.

Taking apart the biggest monster in taperecorders known to mankind.

 

 

 

Well, almost. And, as I found out, the bottom part slides out fairly easy to the front. And it is connected to the rest of the machine with connectors. So in the end you have the bottom part which contains the ‘mainboard’ as I call it as a separate unit on your workbench.
IMG_20131101_135115
IMG_20131101_135124

 

 

 

 

 

Locating the components on the printboard was difficult, but doable. Then soldering started. Using the litze wire to remove the solder from the board, I was able to remove the components.

IMG_20131101_135219

Don’t shake!

IMG_20131101_171544

My old friends. Well, not my friends anymore!

Working methodically through all components, I replaced all 19 of them. Double-checked the joints for good contact. Cut away the excess pins. And I was left with this:Then it was time to test. To do that, the mainboard had to be reinserted into the recorder and reconnected.
And?

It worked! Yeaj! I now have a N4520 that plays back and records beautifully! It took about an afternoon’s work and about ten euro’s, but Then you have successfully restored a very very nice machine.

IMG_20131101_150513

The glorious Philips N4520 in action 

See a video of this beast in action on my YouTube channel:  http://youtu.be/UTS9aYsIH2k

(view count: 4259)

3 thoughts on “Solving famous cracking sound problem: replacing all transistors in mainboard Philips N4520

  1. Dirk

    I own two of the N4520.

    You should also replace all capacitors in signal and bias path.
    I’ve done this with one of my machines. ALL of the capacitors had more capacity than they should have, some of them up to 60 % more!
    For example, a 4,7uF had a capacity of 6,2 uF !
    The reason for this is, that the caps have soken humidity out of the air.

    Reply
  2. alan

    Hello!

    Great job on the overhaul.

    I recently acquired the same machine and can not get it to play sound, the counter does not illuminate as well.

    Could you send me the schematics?
    alan.dubinsky1@gmail.com

    Best,

    Alan

    Reply

Leave a Reply

Your email address will not be published. Required fields are marked *